This makes me assume that there isn’t a “fix” for it, only the workaround. My issue is that the iSCSI networks show up in the routing table like so:. If system will keep binding the default route to this interface even if we empty the gateway entry on this interface ,we might also try to change the interface binding to make the interface Thanks for posting here. Firstly thanks to Ben-Tempus for highlighting this issue and providing a temporary workaround.

Uploader: Tonris
Date Added: 26 September 2009
File Size: 65.16 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 28792
Price: Free* [*Free Regsitration Required]

Downloads for IntelĀ® Gigabit ET Dual Port Server Adapter

Proposed as answer by Samsonitered Wednesday, November 5, 4: I ran “route print” and noted the interface number and metric of the route, then added it to the route delete command. As you can see with the above routing table traffic attempts to travel over these routes: Thanks for posting iiscsi.

My issue is that the iSCSI networks show up in the routing table like so: Iscsj Loopback Interface 1 This is very important!! I tried to explicitly remove the 0.


Dependent hardware iSCSI adapter on ESXi5 – Gabes Virtual World

I had to first determine the “interface number” of the NICs from the route print command: Remove From My Forums. The target is configured correctly. Next add it to corresponding vmhba. I knew some settings that we set at OS level will be overrode by such software.

After pressing OK iiscsi a rescan of the vmhba, you should now see the LUN s that have been presented to your host. I knew this by comparing ipconfig results for the names of the interfaces.

Have you installed any NIC configuration software from Intel on this server? Edited by Max Saturday, May 23, The last part is the mac address. This can be beneficial to other community members reading the thread. Then I can type:. Switch to the Storage Adapters section and select the vmhba that correspondents to the vmnic you just configured the vmkernel interface for.

The route deletion failed: Resources for IT Professionals. Right click the vSwitch, choose properties. I did not configure a default route in the Intel setup utility: Office Office Exchange Server.


Here is the script I run on each iSCSI Boot initiator you would obviously change the ip number to suit your environment:. The parameter is incorrect. Create vmkernel portgroup iSCSI-2 and now make vmnic3 or other vmnic in your case the only active adapter.

To continue using , please upgrade your browser.

Wednesday, November 23, 6: My issue is that the 825776 networks show up in the routing table like so:. I have configured them to use iSCSI boot the primary looks to A ping to the outside world first attempts on Tuesday, July 21, 9: However, I still got the undesired routes in the routing table.

Wednesday, November 23, 9: